Effect of the Preheating Inlet Air on the G222 Fuel Combustion

Mohammed El Hadi Attia, Zied Driss, Abderrahmane Khechekhouche

Abstract

In this paper, a numerical simulation is developed to study the preheating effect of the air in a three-dimensional cylindrical combustion chamber using the FLUENT-CFD code. Particularly, we are interested on the calculation of the characteristic parameters such as the axial velocity, the temperature and the mass fraction of carbon monoxide. This study consists of a special treatment of mathematical models. The considered approaches resolve the governing equations of system. The main objective of this work is to study the behavior of the parameters considered previously during the variation of the air inlet temperature. The obtained results show that the variation of the inlet temperature presents a direct effect on the considered parameters. 

Full Text:

PDF

References

F. Bouras, A. Soudani and M. Si-Ameur, Simulation aux grands échelles de la combustion turbulente couplée à des fonctions densités de probabilité, Proceeding of International Conference on Energetics and Pollution, 2007, pp. 45-50.

F. Tabet, B. Sarhb and I. Gokalp, Hydrogen–hydrocarbon turbulent non-premixed flame structure, International journal of hydrogen energy, vol.34, 2009, pp. 5040–5047.

B. X. Liu, P. Sun, H. Q. Ning, J. Meng, H. Huang, “Simulation of Heat Transfer by Fluid Structure Interaction of Diesel Engine Block - Coolant Jacket”, Journal of Mechanical Engineering Research and Developments, vol. 38, no. 2, 2015, pp. 36-42.

F. Bouras, A.Soudani, and M. Si Ameur, Thermochemistry Study of Internal Combustion Engine, Energy Procedia, vol.18, 2012, pp. 1086–1095.

F. Bouras, A. Soudani, and M. Si Ameur, Beta-PDF Approach for Large Eddy Simulation of Non-premixed Turbulent Combustion, International Review of Mechanics Engineering, vol. 4, 2010, pp. 1096–1099.

C. P. Pierce, P. Moin, Progress-Variable Approach for Large-Eddy Simulation of Non-Premixed Turbulent Combustion, Journal of Fluid Mechanics, vol. 504, 2004, pp 73–97.

J. H. Tang, Y. Y. Zuo, S. Y. Bei, & K. Y. Wang, Numerical Calculation and Analysis of Automobile Aerodynamic Noise Based on Large Eddy Simulation, Journal of Mechanical Engineering Research and Developments, vol. 39, no. 3, 2016, pp. 607-616.

F. Bouras, M.E.H. Attia and F. Khaldi, Entropy Generation Optimization in Internal Combustion Engine, Environ. Process, vol. 02, 2015, pp. 233–242.

F. Bouras, A. Soudani, and M. Si Ameur, Large Eddy Simulation for Lean Premixed Combustion, Canadian Journal of Chemical Engineering, vol. 91, 2013, pp. 231–237.

F. Bouras, A. Soudani, and M. Si Ameur, Numerical Study of the Turbulent Flow Inside an ORACLES Configuration, Trans. ASME, Journal of Appllied Mechnics, vol. 79, 2012, pp. 510-514.

F. Bouras, Numerical study of turbulent structures for lean premixed prevaporized combustion, Journal of Applied Mechanics and Technical Physics, vol. 55, 2014, pp. 614–626.

F. Bouras, M.E.H. Attia, F. Khaldi and M. SI-AMEUR. Control of the Methane Flame Behavior by the Hydrogen Fuel Addition: Application to Power Plant Combustion Chamber, International Journal of Hydrogen energy, vol. 42, 2017, pp. 8932- 8939.

M.E.H. Attia, Z. Driss, A. Khechekhouche. Numerical Study of the Combustion of CH4-C3H8/Air: Application to a Combustion Chamber with Two Coaxial Jets, International Journal of Energetica, vol. 2, no. 2, 2017, pp. 38-42.

M.E.H. Attia, A. Khechekhouche, Z. Driss. Numerical Simulation of Methane-Hydrogen Combustion in the Air: Influence on Combustion Parameters, Indian Journal of Science and Technology, vol. 11, no. 2, 2018, pp. 1-8.

DOI: http://dx.doi.org/10.47238/ijeca.v3i2.75

Refbacks

  • There are currently no refbacks.